GENERAL SPECIFICATIONS
EZ Drive is the only post on the market that can be tied in a knot and yet is so stiff it can withstand high wind loading. This price competitive, moderate impact marker is also the easiest to install.
EZ Drlve has been approved for highway use in some states for moderate and low impact locations such as off-ramps, curbing and barriers. The post is able to withstand up to 50 vehicular impacts at 45mph.
EZ Drive is particularly well suited for marking parks and recreation facilities, buried pipelines, conduits and cables. Installed to the proper depth, it is virtually impossible to pull out of the ground.
HOW TO INSTALL
(1) Uzing our EZ driver or any comparable device, drive a pilot hole 18'' deep.
(2) Slip Drive clamp over the post end and set the assembly over the pre-drilled pilot
hole centering the drive clamp over the hole.
(3) Drive the assembly into the hole until dirt line on the post reaches ground level.
4) The post will come to vertical as it is driven. The drive clamp (bent unto a V shape by the driver) is the anchor.
5) Remove the driver by pulling it straight up. Tamp the dirt around the post for final alignment.
CONSTRUCTION
The post is an all-weather color impregnated, UV stabilized specially formulated polymer extrusion. Drive clamp is mild steel. With the exception of the metal drive clamp, EZ post is 100% post-consumer recycled plastic.
SIZES
Standard heights (above ground) are 3', and 4'. Width: 3.25?". Standard post colors are environmental white, red, orange, yellow, green, blue, brown, and gray. Other lengths and colors available on special order.
